Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1148

Complete Software Guide for Junos
request virtual-chassis renumber
Syntax
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
List of Sample Output
request virtual-chassis request virtual-chassis
renumber member-id renumber member-id
5 new-member-id 4 5 new-member-id 4
request virtual-chassis request virtual-chassis
renumber member-id 1 renumber member-id 1
new-member-id 0 new-member-id 0
1044
®
OS for EX Series Ethernet Switches, Release 10.4
request virtual-chassis renumber member-id old-member-id new-member-id new-member-id
Command introduced in Junos OS Release 9.0 for EX Series switches.
Renumber a member of a Virtual Chassis configuration.
NOTE: You must run this command from the Virtual Chassis member in the
master role.
member-id old-member-id —Specify the ID of the member that you wish to renumber.
new-member-id new-member-id
system-control
request virtual-chassis recycle on page 1043
Replacing a Member Switch of an EX4200 Virtual Chassis Configuration (CLI Procedure)
on page 991
request virtual-chassis renumber member-id 5 new-member-id 4 on page 1044
request virtual-chassis renumber member-id 1 new-member-id 0 on page 1044
user@switch> request virtual-chassis renumber member-id 5 new-member-id 4
user@external-routing-engine> request virtual-chassis renumber member-id 1 new-member-id
0
—Specify an unassigned member ID (from 0 through 9).
Copyright © 2010, Juniper Networks, Inc.