Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1150

Complete Software Guide for Junos
request virtual-chassis vc-port
EX4200 Virtual Syntax
Chassis
EX8200 Virtual
Chassis
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
List of Sample Output
request virtual-chassis request virtual-chassis
vc-port set interface vc-port set interface
1046
®
OS for EX Series Ethernet Switches, Release 10.4
request virtual-chassis vc-port set interface vcp-interface-name
<member member-id> <disable>
request virtual-chassis vc-port set interface vcp-interface-name
member member-id<disable>
Command introduced in Junos OS Release 9.0 for EX Series switches.
Disable or enable a Virtual Chassis port (VCP) on a dedicated VCP on an EX4200 switch.
Configure a Gigabit Ethernet link on an EX8200 switch as a VCP in an EX8200 Virtual
Chassis. This command only needs to be entered to configure a link between two EX8200
member switches as a VCP link; all other links in an EX8200 Virtual Chassis are
automatically VCP links.
interface vcp-interface-name
If you omit
member member-id
dedicated VCP on the switch where the command is issued. The dedicated VCPs
are enabled in the factory default configuration.
member member-id —(Optional on EX4200 switches) Enable or disable the specified
VCP on the specified member of the Virtual Chassis configuration.
This option must be specified when using this command to configure a VCP link
between two EX8200 switches.
disable —(Optional) Disable the specified VCP. If you omit this keyword, the command
enables the dedicated VCP.
system-control
request virtual-chassis vc-port on page 1045
show virtual-chassis vc-port on page 1058
show virtual-chassis vc-port statistics on page 1062
clear virtual-chassis vc-port statistics on page 1040
Understanding EX4200 Virtual Chassis Components on page 893
request virtual-chassis vc-port set interface vcp-0 disable (EX4200 Virtual
Chassis) on page 1046
request virtual-chassis vc-port set fpc-slot 4 pic-slot 0 port 2 member 1 (EX8200
Virtual Chassis) on page 1047
request virtual-chassis vc-port set interface vcp-0 member 3 disable (EX8200 Virtual
Chassis) on page 1047
user@switch> request virtual-chassis vc-port set interface vcp-0 disable
To check the results of this command, use the show virtual-chassis vc-port command.
—Name of the interface to enable or disable.
, this command defaults to disabling or enabling the
Copyright © 2010, Juniper Networks, Inc.