Verifying Ex4200 Virtual Chassis Configuration - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

CHAPTER 40
Verifying EX4200 Virtual Chassis
Configuration
Command Forwarding Usage with an EX4200 Virtual Chassis
Copyright © 2010, Juniper Networks, Inc.
Command Forwarding Usage with an EX4200 Virtual Chassis on page 1007
Verifying the Member ID, Role, and Neighbor Member Connections of an EX4200 Virtual
Chassis Member on page 1010
Verifying That Virtual Chassis Ports on an EX4200 Switch Are Operational on page 1012
Monitoring EX4200 Virtual Chassis Status and Statistics on page 1013
Verifying That Graceful Routing Engine Switchover Is Working in the EX4200 Virtual
Chassis on page 1014
Some CLI commands can be run either on all members or on a specific member of an
EX4200 Virtual Chassis configuration. This functionality is referred to as command
forwarding.
For example, to collect information about your system prior to contacting Juniper Networks
Technical Assistance Center (JTAC), use the command
all-members to gather data for all the member switches. If you want to gather this data
only for a particular member switch, use the command
.
member member-id
Table 153 on page 1008 provides a list of commands that can be run either on all members
of the Virtual Chassis configuration or on a specific member switch.
request support information
request support information
1007