Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1112

Complete Software Guide for Junos
Table 153: Commands That Can be Run on All or Specific Members of the Virtual Chassis
Configuration
Commands Available for
Command Forwarding
request support information
request system partition
hard-disk
request system reboot
request system snapshot
request system storage
cleanup
show log user
1008
®
OS for EX Series Ethernet Switches, Release 10.4
Purpose
Use this command when you
contact JTAC about your
component problem. This
command is the equivalent of
using the following CLI
commands:
show version
show chassis firmware
show chassis hardware
show chassis environment
show interfaces extensive
(for each configured
interface)
show configuration
(excluding any
SECRET-DATA)
show system
virtual-memory
Set up the hard disk for
partitioning. After this
command is issued, the hard
disk is partitioned the next
time the system is rebooted.
When the hard disk is
partitioned, the contents of
/altroot and /altconfig are
saved and restored. All other
data on the hard disk is at risk
of being lost.
Reboot Junos OS for EX
Series switches after a
software upgrade and
occasionally to recover from
an error condition.
Back up the currently running
and active file system.
Free storage space on the
switch by rotating log files
and proposing a list of files for
deletion. User input is required
for file deletion.
Display users who are viewing
the system log.
all-members
Displays information for all
members of the Virtual
Chassis configuration.
Partitions the hard disk on all
members of the Virtual
Chassis configuration.
Reboots all members of the
Virtual Chassis configuration.
Backs up the file systems on
all members of the Virtual
Chassis configuration.
Runs cleanup on all members
of the Virtual Chassis
configuration.
Displays information for all
members of the Virtual
Chassis configuration.
Copyright © 2010, Juniper Networks, Inc.
member-member-id
Displays information for the
specified member switch.
Partitions the hard disk on the
specified member switch.
Reboots the specified
member switch.
Backs up the file system on
the specified member switch.
Runs cleanup on the specified
member switch.
Displays information for the
specified member switch.