Request Virtual-Chassis Vc-Port - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
NOTE: If you do specify the
Because the switch is not yet interconnected with the other members of
the Virtual Chassis configuration, its current member ID is
ID will change when it is interconnected with the Virtual Chassis
configuration. It does not impact the functioning of the uplink VCP that
its VCP interface is set with
significance only on the local switch.
After you have set the uplink VCP on the standalone switch, physically interconnect
3.
its uplink port with the VCP uplink ports of the members in the existing Virtual Chassis
configuration.
The new member switch reboots and joins the now expanded Virtual Chassis
4.
configuration with a different member ID.
NOTE: The setting for the new member switch's uplink VCP remains intact
and is not affected by the change of member ID.
If you have additional members in the second wiring closet, set a redundant VCP
5.
uplink on another member switch by issuing the
command.
Configuring an EX4200 Virtual Chassis (CLI Procedure) on page 981
Configuring an EX4200 Virtual Chassis (J-Web Procedure) on page 985
Example: Configuring an EX4200 Virtual Chassis Interconnected Across Multiple Wiring
Closets on page 932
Example: Configuring an EX4200 Virtual Chassis Using a Preprovisioned Configuration
File on page 952
Monitoring EX4200 Virtual Chassis Status and Statistics on page 1013
Chapter 39: Configuring EX4200 Virtual Chassis
option, use member ID
member member-id
as the member ID. The VCP interface has
0

request virtual-chassis vc-port

.
0
0 . Its member
997