Show Virtual-Chassis Vc-Path - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Complete Software Guide for Junos
Meaning
Related
Documentation
Verifying That Graceful Routing Engine Switchover Is Working in the EX4200 Virtual
Chassis
Purpose
1014
®
OS for EX Series Ethernet Switches, Release 10.4
To view the path a packet takes when going from a source interface to a destination
interface in a Virtual Chassis configuration using the CLI, enter the following command:

show virtual-chassis vc-path

In the J-Web interface the top half of the screen displays details of the Virtual Chassis
configuration, such as:
Member
Role
Interface
Type
Speed
Neighboring Member ID
Link Status
Error count
Click the Stop button to stop fetching values from the switch, and click the
to start plotting data again from the point where it was stopped.
To view a graph of the statistics for the selected VCP of the member, click
—Displays the time interval you have set for page refresh.
Refresh Interval (sec)
Click to clear the monitoring statistics for the selected member switch.
Clear Statistics
You can specify the interval at which the member details and statistics must be refreshed.
The bottom half of the screen displays a chart of the Virtual Chassis statistics and the
port packet counters.
For details about the output from CLI commands, see the show virtual-chassis status
and show virtual-chassis vc-port statistics command summaries.
Configuring an EX4200 Virtual Chassis (CLI Procedure) on page 981
Configuring an EX4200 Virtual Chassis (J-Web Procedure) on page 985
Example: Configuring an EX4200 Virtual Chassis with a Master and Backup in a Single
Wiring Closet on page 917
Verifying the Member ID, Role, and Neighbor Member Connections of an EX4200 Virtual
Chassis Member on page 1010
Verify that graceful Routing Engine switchover (GRES) is working in the EX4200 Virtual
Chassis configuration.
Start
Show Graph
Copyright © 2010, Juniper Networks, Inc.
button
.