Complete Software Guide for Junos
Native VCP Name on the XRE200 External Routing Engine
EX8200 Switch to XRE200 External Routing Engine VCP Name
EX8200 Switch to EX8200 Switch VCP Name
Related
Documentation
Network Port Interface Names on an EX8200 Virtual Chassis
1084
®
OS for EX Series Ethernet Switches, Release 10.4
The native VCP on the XRE200 External Routing Engine—the port located next to the
management (
) port labeled
MGMT
An XRE200 External Routing Engine forms a VCP when it connects to the management
(
MGMT
) port on the Routing Engine (RE) module or the Switch Fabric and Routing Engine
(SRE) module in an EX8200 switch.
The naming for the management port on the EX8200 switch when used as a VCP follows
this format:
vcp-pic/slot
where:
pic is the PIC number, which is always 0 for an EX8200 switch.
slot is the number of the slot containing the RE module or the SRE module.
An EX8200 switch VCP name is always
The names for the Gigabit Ethernet ports configured as VCP links on the EX8200 member
switches follow this format:
vcp-fpc/pic/port
where:
fpc is the slot number of the line card that contains the physical interface.
pic is the PIC number, which is always 0 for an EX8200 switch.
port is the network port number.
vcp-fpc/pic/port names apply to the device that the switch is connected to, not to the
switch itself. Therefore, a VCP link is named according to the connected interface. For
instance, if an external Routing Engine connects to interface
that VCP link is detected as
EX8200 Virtual Chassis Overview on page 1071
Setting a 10-GigabitEthernet Port as a Virtual Chassis Port in an EX8200 Virtual Chassis
(CLI Procedure) on page 1097
Network interfaces in Junos OS are specified as follows:
type-fpc / pic / port
—is always named
0
or
vcp-0/0
vcp-0/1
by the external Routing Engine.
vcp-4/0/3
.
vcp-0/0
.
on an EX8200 switch,
4/0/3
Copyright © 2010, Juniper Networks, Inc.