Novell NETWARE 6-DOCUMENTATION Manual page 3109

FILESYS-X-769: Two volume segments with same sync value have mismatched data.
Source:
Explanation:
Action:
FILESYS-X-770: Volume has no volume name.
Source:
Possible Cause:
Action:
FILESYS-X-771: Volume name name is too short.
Source:
Explanation:
Action:
FILESYS-X-773: Invalid number of volume segments number.
Source:
Possible Cause:
Action:
158 System Messages
If the problem persists, make sure a volume backup exists. Delete the volume,
re-create it, and restore the data from the backup.
FILESYS.NLM
The values specified by two segments on the volume do not match. Another
message should follow this message to indicate which values do not match.
Run VREPAIR and restart the system.
Warning: If you delete the volume, all data will be destroyed. You will have
to restore the data from a backup.
If the problem persists, make sure a volume backup exists. Delete the volume,
re-create it, and restore the data from the backup.
FILESYS.NLM
The MOUNT or DISMOUNT command was issued, but the volume name
was not specified.
Specify a volume name.
FILESYS.NLM
A volume name must be at least two characters long.
Make sure that you typed a valid volume name in the MOUNT console
command and that you spelled it correctly.
FILESYS.NLM
During an attempt to mount a volume, the operating system determined that
the volume contained too many segments (there is an eight segment limit).
Run VREPAIR and restart the system.
Warning: If you delete the volume, all data will be destroyed. You will have
to restore the data from a backup.
If the problem persists, make sure a volume backup exists. Delete the volume,
re-create it, and restore the data from the backup.