Novell NETWARE 6-DOCUMENTATION Manual page 3116

Action:
FILESYS-X-817: Unable to initialize system auditing on volume name. Volume mount
aborted.
Source:
Possible Cause:
Possible Cause:
Action:
FILESYS-X-818: Unable to allocate memory to mount volume name.
Source:
Possible Cause:
Action:
FILESYS-X-820: Overlapping segment entry found starting at offset number on server
for volume name segment number.
Source:
Explanation:
FILESYS-X-823: Drive failed while reading in volume information tables.
Source:
Possible Cause:
Action:
Run VREPAIR and restart the system.
Warning: If you delete the volume, all data will be destroyed. You will have
to restore the data from a backup.
If the problem persists, make sure a volume backup exists. Delete the volume,
re-create it, and restore the data from the backup.
FILESYS.NLM
The operating system cannot open the audit file.
The audit file is already at its maximum size.
Check the size of the auditing file before continuing.
FILESYS.NLM
The server is out of memory.
Increase the memory available to the server. See
Temporarily in the Server Operating System Administration
FILESYS.NLM
This informational message indicates that the operating system found an
overlapping disk area when it tried to mount the volume. The operating system
will discard the volume.
FILESYS.NLM
The drive holding the volume had a physical failure while the volume
information tables were being read.
See Disk Errors in the Server Operating System Administration
FILESYS - File System Messages 165
Freeing Server Memory
Guide.
Guide.