Novell NETWARE 6-DOCUMENTATION Manual page 2736

Statistic
LEM, link rejected
LEM, total errors
Connection state
Table 27
Statistic
UnderrunErrorCount
TransmitTimeoutCount
RxPagingErrorCount
ReceiveFIFOOverrunErrorCount
ReceiverMissedPacketCount
GotNothingCount
UnsupportedFramePacketCount
298 Utilities Reference
Description
The link error monitor (LEM) count of the times that a link was
rejected
The aggregate link error monitor (LEM) error count.
The state of this port's Physical Connection Management (PCM)
state machine:
0=Off; 1=Break; 2=Trace; 3=Connect; 4=Next; 5=Signal; 6=Join;
7=Verify; 8=Active; 9=Maint
Custom Statistics for NE2000, NE2, NE2_32, CNE2_32, and Other Ethernet Drivers
Description
This counter is incremented when the RAM buffer on the network
board is full; the board cannot accept any more packets until the
RAM buffer is cleared.
This counter is incremented when a network board interrupts the
file server with the message that the send bit is lost.
This is a hardware problem caused by faulty cabling, a bad
network board, or a missing terminator.
This is a count of the errors that occur when internal buffers on
the board are corrupted.
This counter is incremented when an incoming packet causes an
overflow because FIFO was not serviced.
This counter is incremented when a packet is sent to a network
board that cannot accept the packet because all its receive
buffers are full.
This counter is incremented when the file server receives an
interrupt from a network board that is not transmitting or receiving
anything.
This is not serious.
This counter is incremented when a packet is received by the
LAN driver with a frame type that hasn't been loaded for the given
board.