Novell NETWARE 6-DOCUMENTATION Manual page 3166

LANSUP-DOS-X-016: The node address was incorrectly specified in the NET.CFG file.
Source:
Possible Cause:
Action:
LANSUP-DOS-X-017: An invalid keyword was specified in NET.CFG on line number.
Source:
Possible Cause:
Action:
LANSUP-DOS-X-018: The frame type specified in the NET.CFG is not supported.
Source:
Possible Cause:
Action:
LANSUP-DOS-X-019: An invalid LANSUP node address is specified in NET.CFG. The
MLID modified the incorrect address bits.
Source:
Possible Cause:
Action:
LANSUP-DOS-X-050: [ISA bus | Microchannel] The board cannot be found.
Source:
Explanation:
Possible Cause:
Action:
Possible Cause:
Action:
LANSUP.COM
The node address override in the NET.CFG file is too long.
Edit the NET.CFG file and correct the node address. The node address must
be less than or equal to 12 hex digits.
LANSUP.COM
The key word on the line indicated was not recognized.
Edit the NET.CFG file and correct the spelling of the keyword.
LANSUP.COM
The frame type specified with the FRAME keyword is not supported by the
driver.
Edit the NET.CFG file and fix frame type.
LANSUP.COM
The node address specified in the NET.CFG file has set reserved bits.
Edit the NET.CFG file and correct the node address.
LANSUP.COM
If the computer is using an ISA bus network board, the network board was not
found due to one or more of the following conditions:
The network board is not present in the computer.
Make sure the network board is properly seated into the slot.
Another network board is using the same hardware settings as this network
board.
If other network boards are using the same hardware settings, change the
settings and try to reload the driver.
LANSUP-DOS Messages 215