Novell NETWARE 6-DOCUMENTATION Manual page 3509

SERVER-X-1542: Module name is a NIOS only NLM.
Source:
Explanation:
Action:
SERVER-X-1543: Could not redirect block number on device number.
Source:
Possible Cause:
Action:
SERVER-X-1544: Warning: There are no more redirection blocks on device name.
Source:
Explanation:
Action:
SERVER-X-1545: Insufficient memory to load NLM.
Source:
Possible Cause:
Action:
SERVER-X-1546: Invalid record in load file.
Source:
Possible Cause:
Action:
558 System Messages
SERVER.EXE
This NLM cannot be run on a server; it must be run on a client.
Run the NLM on a client workstation; or choose a different NLM to load on
the server.
SERVER.EXE
A potential device failure and data loss has been caused by one of the
following:
An I/O error occurred that could not be corrected by Hot Fix. No
redirection blocks are left, or the hard disk is no longer operational.
Due to insufficient space, the system was unable to redirect data during a
Hot Fix operation.
Use the messages that follow this message to determine why Hot Fix has
failed. See Disk Errors
SERVER.EXE
The partition has used all its redirection blocks. Future I/O errors cannot be
redirected to Hot Fix.
The disk is in danger of failing. Troubleshoot or replace the disk.
SERVER.EXE
The server does not have enough memory to load a given NLM.
Increase the memory available to the server. See
Temporarily in the Server Operating System Administration
SERVER.EXE
The operating system tried to load an NLM that had invalid code or data
segments.
Relink the NLM. If the problem persists, contact a Novell support provider or
the vendor of the NLM.
in the Server Operating System Administration
Freeing Server Memory
Guide.
Guide.