Novell NETWARE 6-DOCUMENTATION Manual page 2627

Common File System Parameters
Table 4
Parameter
Maximum Transactions = number
Maximum Concurrent Directory
Cache Writes = number
Minimum File Delete Wait Time = time Specify how long a deleted file remains salvageable on the
Immediate Purge of Deleted Files =
value
Compression Daily Check Stop Hour
= number
Common File System Parameters contain parameters that apply to both the
NSS file system and the traditional file system. For a description of file system
parameters, see the following table.
Common File System Parameters
Use to
Specify how many transactions can occur at the same time.
Supported values: 100 to 10000
Default: 10000
Specify how many write requests from directory cache buffers are
put in the elevator before the disk head begins a sweep across
the disk.
Supported values: 5 to 500
Default: 75
A high number creates more efficient write requests. A low
number creates more efficient read requests.
volume.
Supported values: 0 seconds to 7 days
Default: 1 minute 5.9 seconds
Files deleted for less than this minimum aren't automatically
purged even if the volume is full and users can't create new files.
Supported values: ON, OFF
Default: OFF
If this parameter is set to ON, all files are purged immediately
when they are deleted.
Specify the hour when you want the file compressor to stop
scanning enabled volumes for files that need to be compressed.
Supported values: 0 to 23
Default: 6
Hours are specified by a 24-hour clock: 0 = midnight; 23 = 11 p.m.
This parameter can be set in the STARTUP.NCF file.
Utilities 189