Novell NETWARE 6-DOCUMENTATION Manual page 2720

VREPAIR Options
282 Utilities Reference
The VREPAIR main screen displays the following menu:
Options:
1 - Repair a volume
2 - Set VRepair options
3 - Exit
Main Menu Selection
Repair a volume
Set VRepair options
Exit
In the Set VRepair Options menu, there are two settings for each option, a
default option and an alternate option. When VREPAIR autoloads and tries to
repair a volume that will not mount, the default settings are used.
You can configure the VREPAIR alternate options by selecting the associated
option number to toggle between the alternate and default options.
For example, Option 2 settings are Write All Directory and FAT Entries Out
to Disk and Write Only Changed Directory and FAT Entries Out to Disk.
The default for Option 2 is Write Only Changed Directory and FAT Entries
Out to Disk. If you select Option 2, your current VREPAIR configuration
reflects the change from the default to the new setting: Write All Directory and
FAT Entries Out to Disk.
The VREPAIR configuration options are described in
Use to
Begin or continue with volume repair. You can
also use this option to stop a volume repair in
process or change the method of displaying
errors during the repair.
Set VREPAIR configuration options.
Exit VREPAIR.
Table 22 on page 283.