Novell NETWARE 6-DOCUMENTATION Manual page 2644

Parameter
Auto Restart After Abend = value
206 Utilities Reference
Use to
Specify the system's automatic response to an abend.
Supported values:
0 = The system does not respond to the abend.
1 = After an abend, the system determines the source of the
abend. Based on findings, the system either keeps the computer
running or shuts down the computer and attempts to restart it.
2 = After an abend, the system attempts to recover from the
problem and restart the computer after the time specified by the
Auto Restart After Abend Delay Time parameter.
3 = After an abend, the system immediately restarts the computer.
Default: 1
For values 1, 2, or 3 to take effect, the Developer Option
parameter described in
must be set to OFF.
If the server is to be shut down, the system sends a message
every 2 minutes to warn all connections.
To configure the amount of time the system waits before shutting
down the server, use the Auto Restart After Abend Delay Time
parameter.
After an abend, the screen displays information about the abend.
This information is sent to the ABEND.LOG file on the C: drive.
After the server is shut down and restarted, the ABEND.LOG file
is transferred to SYS:SYSTEM.
Important: Because the server can abend and be restarted
automatically, you should determine whether any abends have
occurred. Periodically check either the ABEND.LOG file or the
Server Up Time field in MONITOR's General Information screen.
"Miscellaneous Parameters" on page 210