Novell NETWARE 6-DOCUMENTATION Manual page 3349

NWCONFIG-X-298: Driver name on line number has no FRAME=<frame name>
parameter. All new Ethernet drivers that have no frame specified will now default to
Ethernet 802.2 frame type, whereas they previously used 802.3. Specify a frame
parameter for this driver.
Source:
Action:
NWCONFIG-X-300: The network number you entered is the IPX internal network
number of this server; it cannot be used to bind to IPX. Enter a different (unique)
number.
Source:
Explanation:
Action:
NWCONFIG-X-301: No LAN drivers are loaded. LAN drivers must be loaded and
bound in order for NWCONFIG to communicate with other v4.x servers and install
Novell eDirectory as part of an existing eDirectory tree.
Source:
Explanation:
Action:
NWCONFIG-X-302: No volumes were found.
Source:
Explanation:
Action:
398 System Messages
NWCONFIG.NLM
If you want a frame type different from the default, you will need to specify it
later.
NWCONFIG.NLM
The network address and the internal network number cannot be the same
number.
If they are the same, change the internal network number of your server;
otherwise, enter the correct network address for this server.
NWCONFIG.NLM
NWCONFIG could not communicate with any other servers because no LAN
drivers have been loaded.
If you want NWCONFIG to see other servers on your network, load and bind
an appropriate LAN driver; then retry the operation.
NWCONFIG.NLM
There are no known volumes on this server.
If you know that volumes exist on this server, make sure the correct disk driver
is loaded and all necessary disks are powered on and connected properly.