Novell NETWARE 6-DOCUMENTATION Manual page 3299

NWCONFIG-X-19: Volume name name must be at least two characters long.
Source:
Explanation:
Action:
NWCONFIG-X-20: A volume was found with an invalid volume block size of number
KB.
Source:
Explanation:
Action:
NWCONFIG-X-21: A volume was found with an invalid number of volume segments
(number). Check to be sure all disk drivers are configured properly.
Source:
Explanation:
Action:
NWCONFIG-X-22: A volume was found with an invalid volume segment position
number of number segments. Check to be sure all disk drivers are configured
properly.
Source:
Explanation:
Action:
NWCONFIG-X-23: A volume was found with an invalid starting sector offset of
number on a drive of size number sectors. Check to be sure all disk drivers are
configured properly.
Source:
Explanation:
Action:
348 System Messages
NWCONFIG.NLM
A volume name was entered which was shorter than two characters.
Enter a name at least two characters long.
NWCONFIG.NLM
An invalid volume has been found. This volume has become corrupted.
Delete the volume. If the data is required, restore it from backups. If the
problem persists, contact a Novell support provider.
NWCONFIG.NLM
An invalid volume has been found. This volume has become corrupted.
Delete the volume. If the data is required, restore it from backups. If the
problem persists, contact a Novell support provider.
NWCONFIG.NLM
An invalid volume has been found. This volume has become corrupted.
Delete the volume. If the data is required, restore it from backups. If the
problem persists, contact a Novell support provider.
NWCONFIG.NLM
An invalid volume has been found. This volume has become corrupted.
Delete the volume. If the data is required, restore it from backups. If the
problem persists, contact a Novell support provider.