Novell NETWARE 6-DOCUMENTATION Manual page 3340

NWCONFIG-X-245: An error occurred during parsing of file name on disk
disk_description, line number, at or near word or symbol name. Error description:
description
Source:
Explanation:
Action:
NWCONFIG-X-246: File name cannot be erased. Error: description.
Source:
Explanation:
Action:
NWCONFIG-X-247: NLM_name did not finish loading in the time allowed (number
seconds). Control will be switched to the system console screen, where you may
either see it finish or enter information to finish loading it.
Source:
Explanation:
Action:
NWCONFIG-X-248: NLM_name did not load. Control will be switched to the system
console screen, where you may see the error.
Source:
Explanation:
Action:
NWCONFIG.NLM
A syntax error was encountered while reading the above file.
If you are writing the script or description file, follow the specifications for
creating the file. If you are not creating the file, contact a Novell support
provider.
NWCONFIG.NLM
This error could result from file I/O errors or from a diskette being write-
protected.
If a diskette is being accessed, make sure it is writable. See
I/O Errors in the Traditional File Services Administration
NWCONFIG.NLM
The specified NLM did not load in the time allotted. The NLM might be
working properly and perhaps no error occurred.
To view the system console screen and determine whether an error occurred,
or to enter information, press Enter. If no error has occurred, proceed
normally.
NWCONFIG.NLM
The specified NLM failed to load.
To view the system console screen and determine what error has occurred,
press Enter.
Resolving Volume
Guide.
NWCONFIG Messages 389