Novell NETWARE 6-DOCUMENTATION Manual page 3149

IDEATA.HAM–005: Exceeded the number of allowed load instances
Source:
Explanation:
IDEATA.HAM–006: Insufficient memory to allocate during initialization
Source:
Possible Cause:
Action:
IDEATA.HAM–007: Invalid NWPA handle
Source:
Possible Cause:
Action:
IDEATA.HAM–008: None of the parameters matched the known resources
Source:
Possible Cause:
Action:
IDEATA.HAM–009: Device not found at the specified port address
Source:
Possible Cause:
Action:
198 System Messages
IDEATA.HAM
This informational message means that you tried to load the .ham driver more
times than allowed. The IDEATA.HAM driver can be loaded four times,
which corresponds to the number of I/O channels currently supported in the
IDE/ATA specification.
IDEATA.HAM
There is insufficient memory to load and run the driver.
Unload any unnecessary NLM programs and try to reload the driver.
IDEATA.HAM
The driver is being passed a bad handle from the NWPA.
Contact Novell Technical Support.
IDEATA.HAM
The load instance failed because the necessary hardware resources (port and
interrupt values) for configuring the .ham driver were not specified on the
command line.
Reload the driver and specify the appropriate hardware resources.
IDEATA.HAM
The driver failed to load because it did not detect any devices at the specified
port address.
Determine the correct port address and reload the driver using this value.