Novell NETWARE 6-DOCUMENTATION Manual page 2837

To
Enable transaction tracking for a file.
Enable TTS to backout transactions without
displaying confirmation prompts.
Log backed out data to the SYS:TTS$LOG.ERR
file.
80
Server Operating System Administration Guide
If TTS has been disabled and you have solved the problems that led to its
disabling, enter one of the following at the System Console prompt to enable
it again:
On a server with traditional volumes: ENABLE TTS
On NSS volume: NSS /Transaction=VolName
To enable and manage transaction tracking for individual files on traditional
volumes, use the commands and parameters in the following table.
Do the following
Use NetWare Remote Manager to flag the file as
transactional. For more information, see
Individual Files in NetWare Remote Manager
Administration Guide.
(Note that files flagged as transactional cannot be
deleted or renamed.)
Place the following command into the
STARTUP.NCF file and restart the server:
SET AUTO TTS BACKOUT FLAG = ON
If this parameter is set to On (default), the backouts
happen automatically.
If this parameter is set to Off, you will be prompted
to confirm file backouts.
You can also set the parameter with NetWare
Remote Manager > Set Parameters > Traditional
File System.
Execute the following command at the System
Console prompt:
SET TTS ABORT DUMP FLAG = ON
If this parameter is set to On, the transactions are
stored in SYS:TTS$LOG.ERR.
If this parameter is set to Off, the transactions are
backed out, but the server does not provide you
with a record of the backouts.
You can also set the parameter with NetWare
Remote Manager > Set Parameters > Traditional
File System.
Viewing