Novell NETWARE 6-DOCUMENTATION Manual page 3112

FILESYS-X-780: Invalid directory table 0 starting block of number on volume of size
number.
Source:
Explanation:
Possible Cause:
Action:
FILESYS-X-781: Invalid directory table 1 starting block of number on volume of size
number.
Source:
Possible Cause:
Action:
FILESYS-X-782: Reserved area is not zero filled.
Source:
Possible Cause:
Action:
FILESYS.NLM
A segment on the primary volume has an inconsistency in the starting point of
the directory table of block pointers.
The table is probably corrupted.
Run VREPAIR on the primary volume.
Warning: If you delete the volume, all data will be destroyed. You will have
to restore the data from a backup.
If the problem persists, make sure a volume backup exists. Delete the volume,
re-create it, and restore the data from the backup.
FILESYS.NLM
A segment on the mirrored volume has an inconsistency in the starting point
of the directory table of block pointers.
Run VREPAIR on the mirrored volume.
Warning: If you delete the volume, all data will be destroyed. You will have
to restore the data from a backup.
If the problem persists, make sure a volume backup exists. Delete the volume,
re-create it, and restore the data from the backup.
FILESYS.NLM
While mounting a volume, the operating system found that the reserved area
of a segment definition was not zero-filled as it should be. Therefore, the
segment was not included in the volume definition table.
Run VREPAIR and restart the system.
Warning: If you delete the volume, all data will be destroyed. You will have
to restore the data from a backup.
If the problem persists, make sure a volume backup exists. Delete the volume,
re-create it, and restore the data from the backup.
FILESYS - File System Messages 161