Novell NETWARE 6-DOCUMENTATION Manual page 3380

NWCONFIG-X-490: NWCONFIG.NLM could not move the old pre-4.1 NDS container
audit file name to the root of the SYS: volume. Old audit information will not be
available for the corresponding container.
Source:
Action:
NWCONFIG-X-491: A NetWare boot partition should be created on at least one of the
devices so that NWCONFIG.NLM can copy NetWare server boot files to that NetWare
boot partition. This will let NetWare boot from that device.
Source:
Explanation:
Action:
NWCONFIG-X-496: NWCONFIG.NLM could not detect any NetWare bOOT partitions.
There must be at least one NetWare BOOT partition that can be identified as a
destination drive.
Source:
Action:
Action:
NWCONFIG-X-501: The installation NLM could not create the language configuration
file LCONFIG.SYS due to some system error. Because of this, the NetWare server is
likely to assume code page 437 during reboot.
Source:
Action:
NWCONFIG-X-502: The installation NLM failed to set the appropriate OS language in
the language configuration file LCONFIG.SYS due to some system error. The NetWare
server may not reboot in the user-preferred language.
Source:
Action:
NWCONFIG.NLM
If old audit information is necessary, contact a Novell support provider.
NWCONFIG.NLM
A NetWare boot partition is required to boot NetWare.
Create at least one NetWare boot partition on one of the devices so that
NWCONFIG.NLM can copy NetWare server boot files to that NetWare boot
partition. This will allow NetWare to boot from that device.
NWCONFIG.NLM
NWCONFIG searched for a NetWare boot partition but failed to find one.
Make sure the correct disk driver is loaded. If a NetWare boot partition was
not created, create a NetWare boot partition on a device. Retry the operation.
If the problem persists, contact a Novell support provider.
NWCONFIG.NLM
If a code page other than 437 is needed, contact a Novell support provider.
NWCONFIG.NLM
If a language other than English is needed, contact a Novell support provider.
NWCONFIG Messages 429