Novell NETWARE 6-DOCUMENTATION Manual page 3579

SPX-X-9: There is no LAN board registered with LSL.
Source:
Explanation:
Action:
SPX-X-10: The name device cannot be loaded by STREAMS.
Source:
Explanation:
Possible Cause:
Action:
Possible Cause:
Action:
SPX-X-11: The name device cannot be loaded by STREAMS.
Source:
Explanation:
Possible Cause:
Action:
Possible Cause:
Action:
SPX-X-12: Module_name STREAM module still in use. Unloading will have unknown
consequences.
Source:
Explanation:
Action:
628 System Messages
SPXS.NLM
An attempt was made to load SPXS before loading a network board. The
operating system must have a board registered with the LSL with a valid IPX
and SPX frame type to initialize SPXS.
Load a network board. Then load SPXS again.
SPXS.NLM
This message is probably preceded by error messages from the STREAMS
module.
The user specified a duplicate or invalid device name.
Make sure that the specified device name is valid, and is not a duplicate.
The user is trying to load too many devices.
Refer to any preceding error messages to help determine the exact cause of the
problem.
SPXS.NLM
This message is probably preceded by error messages from the STREAMS
module.
The user specified a duplicate or invalid device name.
Make sure that the specified device name is valid, and is not a duplicate.
The user is trying to load too many devices.
Refer to any preceding error messages to help determine the exact cause of the
problem.
SPXS.NLM
The indicated module is currently being referenced by another NLM program
or IntranetWare driver. Unloading the module while it is being used might
produce unwanted results.
Wait until the module is not being used. Then try the unload again.