Novell NETWARE 6-DOCUMENTATION Manual page 3323

NWCONFIG-X-147: A NetWare disk partition already exists on this drive.
Source:
Explanation:
Action:
NWCONFIG-X-148: No free space is available on this drive for a NetWare disk
partition.
Source:
Explanation:
Action:
NWCONFIG-X-149: The NetWare disk partition could not be located. The selected
action cannot be completed.
Source:
Explanation:
Action:
NWCONFIG-X-150: Warning: No valid entries for volume name were found on disk.
Source:
Explanation:
Action:
NWCONFIG-X-151: Warning: More than one sync entry exists for volume name.
Source:
Explanation:
Action:
372 System Messages
NWCONFIG.NLM
A physical disk drive can only have one NetWare partition. This message
appears when attempting to create a NetWare disk partition on a disk that
already has one.
If a new NetWare disk partition must be created, delete the existing NetWare
disk partition. This destroys the data on the current NetWare disk partition.
NWCONFIG.NLM
Either there are no free areas on the disk, or the free areas are too small to be
of any benefit.
Get another disk, or delete one of the existing partitions.
NWCONFIG.NLM
The NetWare disk partition was not created correctly.
See Disk Errors in the
NWCONFIG.NLM
Volume name was not found.
Make sure the volume exists and is mounted. Make sure the disk is functioning
correctly; see Disk Errors
Guide.
NWCONFIG.NLM
Multiple disk devices are online that contain volumes with the same name.
Bring the disks that contain these volumes online one at a time, rather than at
the same time. If one of the volumes is old and no longer needed, delete it to
avoid the problem in the future. Two volumes on the same server cannot have
the same name.
Server Operating System Administration
in the Server Operating System Administration
Guide.