Novell NETWARE 6-DOCUMENTATION Manual page 2666

Parameter
TIMESYNC Hardware Clock = value
TIMESYNC Polling Count = number
TIMESYNC Polling Interval = number Specify the long polling interval, in seconds.
TIMESYNC REMOVE Time Source =
server_name
TIMESYNC RESET = value
228 Utilities Reference
Use to
Controls hardware clock synchronization.
Supported values:
ON = The primary and secondary time servers set the hardware
clock, and the single reference and reference time servers set
their time from the hardware clock at the beginning of each polling
interval
OFF = Use only if this server uses an external time source (such
as a radio clock)
Default: ON
Specify how many time packets to exchange while polling.
Increasing the number of packets adds unnecessary traffic to the
network.
Supported values: 1 to 1000
Default: 3
Supported values: 10 to 2678400 seconds (31 days)
Default: 600 seconds (10 minutes)
All servers in the same tree must use the same setting.
Delete a server as a time source.
Use EDIT, rather than this parameter, to delete a server from the
time source list in the TIMESYNC.CFG file.
Maximum: 48 characters
Reset time synchronization and clear the time source list.
Use EDIT, rather than this parameter, to reset values in the
TIMESYNC.CFG file and to remove the time source list from the
file.
Supported values:
ON = Selected internal values are reset and the configured server
list is cleared. Flag automatically resets to OFF.
Default: OFF