Novell NETWARE 6-DOCUMENTATION Manual page 3316

NWCONFIG-X-107: The operation aborted because BTRIEVE.NLM could not be
loaded.
Source:
Explanation:
Action:
NWCONFIG-X-108: The operation aborted because the
SYS:SYSTEM\PRODUCTS.DAT file could not be accessed.
Source:
Explanation:
Action:
NWCONFIG-X-109: BTRIEVE error number occurred while function number was
being executed.
Source:
Explanation:
Action:
NWCONFIG-X-110: This product has no configuration options.
Source:
Explanation:
Action:
NWCONFIG.NLM
BTRIEVE.NLM could not be loaded. This could be caused by insufficient
memory or conflicts with exported functions.
The system console screen should indicate the cause of Btrieve not being
loaded. Examine this screen to determine the necessary steps for resolving the
conflict. If the problem is due to insufficient memory, increase the memory
available to the server. See
Operating System Administration
Novell support provider.
NWCONFIG.NLM
To install products, the above file must be accessible.
Make sure volume SYS: is mounted. (Switch to the console screen and enter
volumes.) If it is, restore the PRODUCTS.DAT file from backup or from
some other source; then retry the action. If the problem persists, contact a
Novell support provider.
NWCONFIG.NLM
NWCONFIG received an error from Btrieve.
Look up the error in a Btrieve manual and take appropriate action, or contact
a Novell support provider.
NWCONFIG.NLM
There are no options for configuration.
Pressing Enter is not a supported action for this product. Try reinstalling the
product and configure it differently. If the problem persists, contact a Novell
support provider.
Freeing Server Memory Temporarily
Guide. If the problem persists, contact a
NWCONFIG Messages 365
in the Server