Novell NETWARE 6-DOCUMENTATION Manual page 3165

LANSUP-DOS-X-012: The protocol keyword must have a frame type. Entry ignored.
Source:
Possible Cause:
Action:
LANSUP-DOS-X-013: The MLID could not register Protocol ID number for protocol
stack name for frame type frame.
Source:
Possible Cause:
Action:
LANSUP-DOS-X-014: This version of the LSL is not supported.
Source:
Explanation:
Action:
LANSUP-DOS-X-015: The frame type is already active for frame type.
Source:
Possible Cause:
Action:
214 System Messages
LANSUP.COM
The PROTOCOL keyword entry is incomplete.
Correct the protocol entry in the NET.CFG file. The proper syntax for the
protocol keyword is as follows:
PROTOCOL LANSUP
LANSUP.COM
The Link Support Layer (LSL) is configured with resources for a set number
of Protocol Identifiers. (The default is 4.) This number has been exceeded.
Edit the NET.CFG file, and add the MAX STACKS keyword to reflect the
number of network boards to be loaded, as in the following example:
LINK SUPPORT
MAX STACKS 6
Unload the driver; then reload it as in the following example:
C:\NWCLIENT\LANSUP /u <Enter>
C:\NWCLIENT\LSL /u <Enter>
C:\NWCLIENT\LSL <Enter>
C:\NWCLIENT\LANSUP <Enter>
LANSUP.COM
The driver the computer is using supports only Link Support Layer (LSL)
versions later than 1.0.
Unload the LSL and replace it with a newer version.
LANSUP.COM
The frame type is already loaded, and it cannot be loaded repeatedly.
Edit the NET.CFG file to load the frame type only once for a given network
board.
hex_protocol_ID frame_type