Novell NETWARE 6-DOCUMENTATION Manual page 2647

Parameter
Memory Protection Fault Cleanup =
value
Garbage Collection Interval = number Specify the maximum time between garbage collections.
Alloc Memory Check Flag = value
Reserved Buffers Below 16 Meg =
number
Use to
Enable the server to clean up a protected address space that has
faulted.
Supported Values: ON, OFF
Default: ON
If this parameter is ON and a protected address space faults, the
server removes the address space and its NLM
returns the resources to the system.
If this parameter is OFF and a protected address space faults, the
server does not remove the address space or return resources to
the system. The situation is left to the abend recovery
mechanism.
You can set this parameter in the STARTUP.NCF file.
Supported values: 1 minute to 1 hour
Default: 5 minutes
You can set this parameter in the STARTUP.NCF file.
Specify whether the server will check for corruption in the alloc
memory nodes.
Supported values: ON, OFF
Default: OFF
You can set this parameter in the STARTUP.NCF file.
Specify the number of file cache buffers reserved for device
drivers that can't access memory above 16 MB.
Supported values: 8 to 2000
Default: 300
You must set this parameter in the startup.ncf file. You cannot set
the value at the command line.
programs and
TM
Utilities 209