Novell NETWARE 6-DOCUMENTATION Manual page 3048

FILESYS-X-158: Internal compression error: file `name' volume number intermediate
size number. Offset totals from intermediate file generation (number) and
intermediate file processing (number) mismatch invalidating intermediate file.
Source:
Possible Cause:
Action:
FILESYS-X-159: Internal compression error: file `name' volume number intermediate
size number. Data encode counts from intermediate file generation (encode_count)
and intermediate file processing (encode_count) mismatch invalidating intermediate
file.
Source:
Explanation:
Action:
FILESYS.NLM
This error resulted from an internal consistency check done by compression to
guarantee the integrity of the data being compressed. During file compression,
an intermediate file is created that describes the compressed version of the file.
The file contains codes describing what should be encoded in the compressed
version of the file. The totals from processing the original file do not match
the totals from processing the intermediate file. This would only be caused by
insufficient memory or by a disk returning corrupted data. The file that was
being compressed will remain uncompressed, and the system will try again
later to compress it.
No immediate action is necessary. Note the volume number and watch for
more of these same alerts. Also, watch for other errors indicating that the
memory or disk is failing. If these alerts or other data corruption problems
happen often on a particular volume, the disk or hardware supporting the disk
should be repaired or replaced.
FILESYS.NLM
This is an internal consistency check done by compression to guarantee the
integrity of the data being compressed. The file that was being compressed
will remain uncompressed, and the system will try again later to compress it.
No immediate action is necessary. Note the volume number and watch for
more of these same alerts. Also, watch for other errors indicating that the
memory or disk is failing. If these alerts or other data corruption problems
happen often on a particular volume, the disk or hardware supporting the disk
should be repaired or replaced.
FILESYS - File System Messages
97