Novell NETWARE 6-DOCUMENTATION Manual page 3377

NWCONFIG-X-479: Warning: An attempt to open configuration file AUTOEXEC.NCF
failed. This may be due to volume SYS: being dismounted or inaccessible.
You may still configure drivers, but later you will have to manually add the LOAD
commands to the configuration file if you want the driver LOAD operations to remain
after the server reboots.
Source:
Explanation:
Action:
NWCONFIG-X-480: Warning: An attempt to open configuration files IOAUTO.NCF and
MSAUTO.NCF failed. Error code: code
You may still configure drivers, but later you will have to manually add the LOAD
commands to the configuration file if you want the driver LOAD operations to remain
after the server reboots.
Source:
Action:
NWCONFIG-X-481: The NetWare/IP product environment could not be set up. The
reason could be that CLIB.NLM or BTRIEVE.NLM did not load. Refer to the NetWare
system console for the actual reason.
Source:
Action:
426 System Messages
NWCONFIG.NLM
Due to an internal error, the load commands will not be automatically inserted
into the AUTOEXEC.NCF file.
See Resolving File I/O Errors
Guide. You can also do as the message states and manually edit the
AUTOEXEC.NCF file by loading NWCONFIG and selecting NCF File
Options > Edit AUTOEXEC.NCF File.
NWCONFIG.NLM
See Resolving File I/O Errors
Guide. You can also do as the message states and manually edit the
IOAUTO.NCF and MSAUTO.NCF files by loading NWCONFIG and
selecting Maintenance/Selective Install.
NWCONFIG.NLM
Refer to the NetWare system console screen for the reason the NetWare/IP
environment could not be set up, and take the appropriate action. If an NLM
could not be loaded, make sure that it is the proper version and see
File I/O Errors in the
in the Traditional File Services Administration
in the Traditional File Services Administration
Traditional File Services Administration
Resolving
Guide.