Novell NETWARE 6-DOCUMENTATION Manual page 2642

Parameter
Boot Error Log File State = number
Boot Error Log File Overflow Size =
number
Boot Error Log = value
Hung Unload Wait Delay = number
204 Utilities Reference
Use to
Control what happens when the BOOT$LOG.ERR file is larger
than the size specified by the Boot Error Log Overflow Size
parameter.
Supported values:
0 = Leave BOOT$LOG.ERR as is
1 = Delete BOOT$LOG.ERR
2 = Rename BOOT$LOG.ERR
3 = Start a new log file whenever the server is restarted
Default: 3
You can set this parameter in the STARTUP.NCF file.
Specify the maximum size to which the BOOT$LOG.ERR file can
grow before the action specified by the Boot Error Log File State
parameter occurs.
Supported values: 65536 to 4294967295
Default: 4194304
You can set this parameter in the STARTUP.NCF file.
Specify which error messages from the console will be saved in
the BOOT$LOG.ERR file.
Supported values: ON, OFF
Default: ON
If you set this parameter to ON, all error messages displayed on
the console will be saved in BOOT$LOG.ERR.
If you set this parameter to OFF, only error messages displayed
during the boot procedure will be saved in BOOT$LOG.ERR.
You can set this parameter in the STARTUP.NCF file.
Specify the amount of time the server waits for an NLM to be
unloaded from a protected address space after the UNLOAD
ADDRESS SPACE command is executed. If the NLM is not
successfully unloaded within this interval, the server displays a
prompt to kill the address space.
Supported values: 0 seconds to 1 minute 58.3 seconds
Default: 30 seconds
You can set this parameter in the STARTUP.NCF file.