Novell NETWARE 6-DOCUMENTATION Manual page 3305

NWCONFIG-X-46: The program could not allocate memory for the file system
directory table.
Source:
Explanation:
Action:
NWCONFIG-X-47: An error occurred while writing name file system directory block
sequence number.
Source:
Explanation:
Action:
NWCONFIG-X-48: The program could not find a free block to redirect the file system
directory block to.
Source:
Explanation:
Action:
NWCONFIG-X-49: End of file was encountered unexpectedly in the system directory
file, FAT chain at sequence number.
Source:
Explanation:
Action:
NWCONFIG-X-50: An attempt to read a primary file system directory entry failed.
Source:
Explanation:
Action:
354 System Messages
NWCONFIG.NLM
There is insufficient memory to accomplish the desired operation.
See Freeing Server Memory Temporarily
Administration Guide.
NWCONFIG.NLM
NWCONFIG could not write to the volume. This could indicate an internal
system error.
See Resolving Volume I/O Errors
Administration Guide..
NWCONFIG.NLM
The volume might be full or the drive parameters might not be set up correctly.
This message could also indicate a bug in the program.
If possible, try specifying a larger volume size. Also check the drive
parameters. If the problem persists, contact a Novell support provider.
NWCONFIG.NLM
An internal system error has occurred.
Try again. If the problem persists, contact a Novell support provider.
NWCONFIG.NLM
An error occurred when the program attempted to read a volume.
See Resolving Volume I/O Errors
Administration Guide.
in the Server Operating System
in the Traditional File Services
in the Traditional File Services