Novell NETWARE 6-DOCUMENTATION Manual page 3591

24: The system could not push a list onto the stack because the list stack is already
full.
Source:
Possible Cause:
Action:
25: The system could not pop a list from the stack because the list stack is empty.
Source:
Possible Cause:
Action:
26: The system cannot display the utility header with the current date and time.
Source:
Possible Cause:
Action:
28: The system could not allocate number bytes of additional memory.
Source:
Possible Cause:
Action:
29: File name could not be opened.
Source:
Possible Cause:
Action:
Possible Cause:
Action:
640 System Messages
utility name in message prefix
To initialize a new list, the old list must be pushed onto the stack. The program
could not accommodate the request as described. Too many lists are active in
the program at one time. This is a program logic error.
Contact a Novell support provider.
utility name in message prefix
The program attempted to retrieve a list when none was saved. This is a
program logic error.
Contact a Novell support provider.
utility name in message prefix
The most likely cause of this error is a text string that is too long to display.
This could result from messages expanding due to translation.
Contact a Novell support provider.
utility name in message prefix
The workstation does not have sufficient memory to complete the attempted
operation.
Increase the memory available to the workstation. See
Workstation Memory Problems" on page
utility name in message prefix
The user does not have access rights to the file.
Make sure the file is flagged properly.
A file is corrupted.
If the user has a corrupted file, replace it, if possible.
"Resolving
787.