Novell NETWARE 6-DOCUMENTATION Manual page 2990

CX Messages
CX-X-120: Control characters are not allowed in the command line.
Source:
Explanation:
Action:
CX-X-215: The context you are trying to change to is invalid. Your current context will
be left unchanged.
Source:
Explanation:
Action:
CX-X-220: An error occurred during CX's attempt to create the context.
Source:
Explanation:
Possible Cause:
Action:
The following messages include messages from the CX.EXE.
CX.EXE
Control character input is not allowed as a CX parameter. The key stroke
sequences <Ctrl>+<C> and <Ctrl>+<Break> will abort the CX command.
Retry the command without using control characters in parameters.
CX.EXE
After getting a context handle, CX encountered an error when it tried to set the
desired context. CX has terminated.
Make sure that you are using a valid context; then try again.
CX.EXE
CX could not create a context handle. CX has terminated.
The library call NWCreateContext () failed because of insufficient memory at
the server.
Increase the memory available to the server. See
Temporarily in Server Operating System Administration
If the problem persists, contact a Novell support provider.
Freeing Server Memory
Guide, then try again.
CX Messages
39