Novell NETWARE 6-DOCUMENTATION Manual page 3490

SERVER-X-508: Invalid resource tag passed to RegisterHardwareOptions.
Source:
Explanation:
Possible Cause:
Action:
Possible Cause:
Action:
SERVER-X-510: CheckAndAddHardware could not allocate a resource tag.
Source:
Possible Cause:
Action:
SERVER.EXE
An NLM was trying to register hardware that it needed to use. The server
detected that the resource tag passed as a parameter to the
RegisterHardwareOptions routine was not valid. The hardware was not
registered, and the server returned an error to the NLM. The NLM will not be
able to perform properly. The NLM might have had a problem when it tried to
get the resource tag before calling RegisterHardwareOptions.
If the server is low on memory, the request to create the resource tag might
have failed. In this case a preceding error message should indicate the out- of-
memory problem.
Increase the memory available to the server. See
Temporarily in the Server Operating System Administration
There could also be a bug in the NLM that is calling RegisterHardwareOptions
with an invalid resource tag.
If memory is not the problem and the error persists, contact the vendor for an
updated version of the NLM.
SERVER.EXE
This error could occur for one of the following reasons:
The NLM made a call to an API for a previous version of NetWare or
IntranetWare.
The operating system tried to allocate memory for the resource, but the
server does not have enough memory.
In either case, the NLM that called CheckAndAddHardware is not able to
register the hardware resources that it needs to use. The NLM will not be able
to function properly.
Increase the memory available to the server. See
Temporarily in the Server Operating System Administration
persists, contact a Novell support provider or the NLM vendor.
Freeing Server Memory
Guide.
Freeing Server Memory
Guide. If the error
SERVER Messages 539