HP E4510-48G Command Reference Manual page 187

View
System view
Default Level
2: System level
Parameters
vlan-id1, vlan-id2: VLAN ID, in the range 1 to 4094.
vlan-id1 to vlan-id2: Specifies a VLAN range. A VLAN ID is in the range 1 to 4094. Note that vlan-id2
must be equal to or greater than vlan-id1.
all: Creates or removes all VLANs except reserved VLANs. The keyword is not supported when the
maximum number of VLANs that can be created on a device is less than 4094.
Description
Use the vlan vlan-id command to create a VLAN and enter its view or enter the view of an existing
VLAN.
Use the vlan vlan-id1 to vlan-id2 command to create a range of VLANs specified by vlan-id1 to
vlan-id2, except reserved VLANs.
Use the undo vlan command to remove the specified VLAN(s).
As the default VLAN, VLAN 1 cannot be created or removed.
You cannot create/remove reserved VLANs reserved for specific functions.
You cannot use the undo vlan command to directly remove reserved VLANs, voice VLANs,
management VLANs, dynamic VLANs, VLANs configured with QoS policies, control VLANs
configured for smart link, or remote probe VLANs configured for port mirroring. To remove these
VLANs, you need to first remove related configurations.
Related commands: display vlan.
Examples
# Enter VLAN 2 view.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2]
# Create VLAN 4 through VLAN 100.
<Sysname> system-view
[Sysname] vlan 4 to 100
Please wait............. Done.
6-8