Reset Stp; Revision-Level - HP E4510-48G Command Reference Manual

Related commands:
region-configuration, check region-configuration, active region-configuration.
Examples
# Set the MST region name of the device to hello.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] region-name hello

reset stp

Syntax
reset stp [ interface interface-list ]
View
User view
Default Level
1: Monitor level
Parameters
interface interface-list: Specifies a port list, in the format of interface-list = { interface-type
interface-number [ to interface-type interface-number ] }&<1-10>, where &<1-10> indicates that you
can specify up to 10 ports or port ranges.
Description
Use the reset stp command to clear the MSTP statistics information.
The MSTP statistics information includes the numbers of TCN BPDUs, configuration BPDUs, RST
BPDUs and MST BPDUs sent/received through the specified ports (STP BPDUs and TCN BPDUs are
counted only for the CIST).
Note that this command clears the spanning tree-related statistics information on the specified ports if
you specify the interface-list argument; otherwise, this command clears the spanning tree-related
statistics on all ports.
Related commands: display stp.
Examples
# Clear the spanning tree-related statistics information on ports GigabitEthernet 1/0/1 through
GigabitEthernet 1/0/3.
<Sysname> reset stp interface gigabitethernet 1/0/1 to gigabitethernet 1/0/3

revision-level

Syntax
revision-level level
undo revision-level
instance, revision-level,
4-16
vlan-mapping modulo, display stp