Display Garp Timer - HP E4510-48G Command Reference Manual

GARP statistics on port GigabitEthernet1/0/1
Number of GVRP Frames Received
Number of GVRP Frames Transmitted
Number of Frames Discarded
GARP statistics on port GigabitEthernet1/0/2
Number of GVRP Frames Received
Number of GVRP Frames Transmitted
Number of Frames Discarded

display garp timer

Syntax
display garp timer [ interface interface-list ]
View
Any view
Default Level
1: Monitor level
Parameters
interface interface-list: Defines one or multiple Ethernet ports. You can provide up to 10 Ethernet port
lists, by each of which you can specify an individual port in the form of interface-type interface-number,
or a port range in the form of interface-type interface-number1 to interface-type interface-number2,
where the end-port number specified by interface-number2 must be greater than the start-port number
specified by interface-number1. If no ports are specified, this command displays the GARP timer
settings on all ports.
Description
Use the display garp timer command to display GARP timer settings of specific ports.
Related commands: garp timer hold, garp timer join, garp timer leave, garp timer leaveall.
Examples
# Display GARP timers on port GigabitEthernet 1/0/1.
<Sysname> display garp timer interface gigabitethernet 1/0/1
GARP timers on port GigabitEthernet1/0/1
Garp Join Time
Garp Leave Time
Garp LeaveAll Time
Garp Hold Time
: 0
: 0
: 0
: 0
: 0
: 0
: 20 centiseconds
: 60 centiseconds
: 1000 centiseconds
: 10 centiseconds
9-2