Bootp Client Configuration Commands; Display Bootp Client - HP E4510-48G Command Reference Manual

8

BOOTP Client Configuration Commands

BOOTP client configuration can only be used on VLAN interfaces.
If several VLAN interfaces sharing the same MAC address obtain IP addresses through a BOOTP
relay agent, the BOOTP server cannot be a Windows 2000 Server or Windows 2003 Server.
You are not recommended to enable both the DHCP client and the DHCP snooping on the same
device. Otherwise, DHCP snooping entries may fail to be generated, or the BOOTP client may fail
to obtain an IP address.
BOOTP Client Configuration Commands

display bootp client

Syntax
display bootp client [ interface interface-type interface-number ]
View
Any view
Default Level
1: Monitor level
Parameters
interface interface-type interface-number: Displays the BOOTP client information of the interface.
Description
Use the display bootp client command to display related information about a BOOTP client.
Note:
If interface interface-type interface-number is not specified, the command will display information
about BOOTP clients on all interfaces.
If interface interface-type interface-number is specified, the command will display information
about the BOOTP client on the specified interface.
Examples
# Display related information of the BOOTP client on VLAN-interface 1.
<Sysname> display bootp client interface vlan-interface 1
8-1