Display Ip-Subnet-Vlan Vlan - HP E4510-48G Command Reference Manual

Parameters
interface-list: Specifies an Ethernet port list in the format of interface-list = { interface-type
interface-number
interface-number represents the port type and port number and &<1-10> indicates that you can specify
up to 10 ports or port ranges.
all: Displays IP subnet-based VLAN information about all the ports with IP subnet-based VLAN
configured.
Description
Use the display ip-subnet-vlan interface command to display IP subnet-based VLANs and IP subnet
indexes on the specified port(s).
Examples
# Display IP subnet-based VLANs and IP subnet indexes on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname]display ip-subnet-vlan interface gigabitethernet 1/0/1
Interface: GigabitEthernet1/0/1
VLAN ID Subnet-Index
=======================================================
3
Table 6-6 display ip-subnet-vlan interface command output description
Field
Interface
VLAN ID
Subnet-Index
IP ADDRESS
NET MASK

display ip-subnet-vlan vlan

Syntax
display ip-subnet-vlan vlan { vlan-id [ to vlan-id ] | all }
View
Any view
Default Level
2: System level
Parameters
vlan-id: VLAN ID, in the range 1 to 4094.
to: Specifies a VLAN ID range. The argument after this keyword must be greater than or equal to the
one before this keyword.
[ to interface-type
IP ADDRESS
0 192.168.1.0
Interface of which you want to view the information
VLAN ID
Index of the IP subnet
IP address of the subnet (either an IP address or a network address)
Mask of the IP subnet
interface-number ] }&<1-10>,
NET MASK
255.255.255.0
Description
6-28
where interface-type