Mirroring-Group Remote-Probe Vlan - HP E4510-48G Command Reference Manual

The destination mirroring port can be an access, trunk, or hybrid port. It must be assigned to the
remote mirroring VLAN.
A remote source port mirroring group cannot contain destination ports.
Before configuring the destination port for a port mirroring group, make sure the port mirroring
group exists.
Do not enable STP, RSTP, or MSTP on the destination port. Otherwise, the mirroring function
may be affected.
Do not use the destination mirroring port for any purpose other than port mirroring.
Examples
# Configure GigabitEthernet 1/0/1 as the monitor port in remote destination mirroring group 1.
<Sysname> system-view
[Sysname] mirroring-group 1 remote-destination
[Sysname] mirroring-group 1 monitor-port GigabitEthernet 1/0/1

mirroring-group remote-probe vlan

Syntax
mirroring-group groupid remote-probe vlan rprobe-vlan-id
undo mirroring-group groupid remote-probe vlan rprobe-vlan-id
View
System view
Default Level
2: System level
Parameters
groupid: Number of a remote source or destination mirroring group, in the range of 1 to 4.
rprobe-vlan-id: ID of the VLAN to be configured as the remote probe VLAN. This VLAN must be a static
VLAN that already exists.
Description
Use the mirroring-group remote-probe vlan command to specify a VLAN as the remote probe VLAN
for a remote source or destination mirroring group.
Use the undo mirroring-group remote-probe vlan command to remove the remote probe VLAN
from the remote source or destination mirroring group.
Note that:
Only remote source port mirroring groups or remote destination port mirroring groups can have
remote mirroring VLANs. A port mirroring group can have only one remote mirroring VLAN.
To remove a VLAN operating as a remote port mirroring VLAN, you need to restore it to a normal
VLAN first. A remote port mirroring group gets invalid if the corresponding remote port mirroring
VLAN is removed.
You are recommended to use a remote mirroring VLAN for remote mirroring only.
12-6