HP E4510-48G Command Reference Manual page 94

View
Any view
Default Level
1: Monitor level
Parameters
bridge-aggregation: Displays the load sharing mode of the aggregation group corresponding to the
specified Layer 2 aggregate interface.
interface-number: Specifies the number of an existing aggregate interface.
Description
Use the display link-aggregation load-sharing mode command to display load sharing mode for link
aggregation groups.
To display the global link aggregation load sharing mode, perform the command without the interface
keyword.
To display the load sharing mode of the aggregation group corresponding to each aggregate interface,
perform the command with the interface keyword but do not specify a particular interface.
To display the load sharing mode of a particular aggregation group, perform the command with the
aggregate interface specified.
Examples
# Display the default global link aggregation load sharing mode.
<Sysname> display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Mode:
Layer 2 traffic: destination-mac address, source-mac address
Layer 3 traffic: destination-ip address, source-ip address
# Display the configured global link aggregation load sharing mode.
<Sysname> display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Mode:
destination-mac address, source-mac address
# Display the default link aggregation load sharing mode of the aggregation group corresponding to
Layer 2 aggregate interface Bridge-Aggregation 10.
<Sysname> display link-aggregation load-sharing mode interface bridge-aggregation 10
Bridge-Aggregation1 Load-Sharing Mode:
Layer 2 traffic: destination-mac address, source-mac address
Layer 3 traffic: destination-ip address, source-ip address
# Display the configured link aggregation load sharing mode of the aggregation group corresponding
to Layer 2 aggregate interface Bridge-Aggregation 10.
<Sysname> display link-aggregation load-sharing mode interface bridge-aggregation 10
2-3