Remark Customer-Vlan-Id; Remark Service-Vlan-Id - HP A5830 Series Command Reference Manual

Parameters
None
Examples
# Enable network-side QinQ on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qinq enable uplink
# Enable network-side QinQ on port group 1.
<Sysname> system-view
[Sysname] port-group manual 1
[Sysname-port-group-manual-1] group-member gigabitethernet 1/0/1 to gigabitethernet 1/0/6
[Sysname-port-group-manual-1] qinq enable uplink

remark customer-vlan-id

Description
Use the remark customer-vlan-id command to add a CVLAN marking action to a traffic behavior.
Use the undo remark customer-vlan-id command to remove the action from the traffic behavior.
The remark customer-vlan-id action cannot be applied to a VLAN or applied globally.
Syntax
remark customer-vlan-id vlan-id
undo remark customer-vlan-id
View
Traffic behavior view
Default level
2: System level
Parameter
vlan-id: Specifies a customer VLAN (CVLAN) ID, ranging from 1 to 4094.
Example
# Configure traffic behavior b1 to mark matching packets with CVLAN 1 1 1.
<Sysname> system-view
[Sysname] traffic behavior b1
[Sysname-behavior-b1] remark customer-vlan-id 111

remark service-vlan-id

Description
Use the remark service-vlan-id command to add an SVLAN marking action to a traffic behavior.
Use the undo remark service-vlan-id command to remove the action from the traffic behavior.
208