Shutdown - HP E4510-48G Command Reference Manual

View
User view
Default Level
1: Monitor level
Parameters
interface-type interface-number: Interface type and interface number.
to: Specifies an interface range in the form of interface-type interface-number to interface-type
interface-number, where the start interface number must be smaller than the end interface number.
Note that both the start interface and the end interface are inclusive.
Description
Use the reset lacp statistics command to clear the LACP statistics for the specified interface(s) or all
interfaces if no interface is specified.
Related commands: display link-aggregation member-port.
Examples
# Clear the LACP statistics for all Ethernet ports.
<Sysname> reset lacp statistics

shutdown

Syntax
shutdown
undo shutdown
View
Layer-2 aggregate interface view
Default Level
2: System level
Parameters
None
Description
Use the shutdown command to shut down the current aggregate interface/subinterface.
Use the undo shutdown command to bring up the current aggregate interface/subinterface.
By default, aggregate interfaces are enabled.
Examples
# Shut down aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
2-17