Qinq Enable - HP E4510-48G Command Reference Manual

Examples
# Configure GigabitEthernet 1/0/1 to tag frames of VLAN 3, VLAN 5, and VLAN 20 through VLAN 100
with SVLAN 100.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qinq vid 100
[Sysname-GigabitEthernet1/0/1-vid-100] raw-vlan-id inbound 3 5 20 to 100

qinq enable

Syntax
qinq enable
undo qinq enable
View
Ethernet interface view, Layer-2 aggregate interface view, port group view
Default Level
2: System level
Parameters
None
Description
Use the qinq enable command to enable basic QinQ on the current Ethernet port(s).
Use the undo qinq enable command to disable basic QinQ on the current Ethernet port(s).
By default, basic QinQ is disabled on Ethernet ports.
A basic QinQ-enabled port tags received frames with the port's default VLAN tag.
Note that:
Configuration made in Ethernet interface view takes effect on the current port only. Configuration
made in Layer-2 aggregate interface view takes effect on the Layer-2 aggregate interface and the
member ports in its aggregation group. Configuration made in port group view takes effect on all
ports in the port group.
You can configure this command on a Layer-2 aggregate interface and its member ports
separately. Configuration made on an aggregation member port takes effect immediately. For
detailed information about link aggregation, refer to Link Aggregation Configuration in the Access
Volume.
Examples
# Enable basic QinQ on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qinq enable
# Enable basic QinQ on port group 1.
<Sysname> system-view
10-3