Stp Cost - HP E4510-48G Command Reference Manual

View
System view, Ethernet interface view, port group view, Layer 2 aggregate interface view
Default Level
2: System level
Parameters
None
Description
Use the stp config-digest-snooping command to enable Digest Snooping.
Use the undo stp config-digest-snooping command to disable Digest Snooping.
The feature is disabled by default.
Note that:
Configured in system view, the setting takes effect globally; configured in Ethernet interface view,
the setting takes effect on the current interface only; configured in port group view, the setting
takes effect on all ports in the port group.
Configured in Layer 2 aggregate interface view, the setting takes effect only on the aggregate
interface; configured on a member port in an aggregation group, the setting can take effect only
after the port leaves the aggregation group.
You need to enable this feature both globally and on ports connected to third-party devices to
make it take effect. It is recommended to enable the feature on all associated ports first and then
globally, making all configured ports take effect at the same time to minimize the impact on the
network, and disable the feature globally to disable it on all associated ports.
Related commands: display stp.
Examples
# Enable Digest Snooping on GigabitEthernet 1/0/1 and then globally.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] stp config-digest-snooping
[Sysname-GigabitEthernet1/0/1] quit
[Sysname] stp config-digest-snooping

stp cost

Syntax
stp [ instance instance-id ] cost cost
undo stp [ instance instance-id ] cost
View
Ethernet interface view, port group view, Layer 2 aggregate interface view
Default Level
2: System level
4-20