Display Ipv6 Neighbors Count - HP E4510-48G Command Reference Manual

You can use the reset ipv6 neighbors command to clear specific IPv6 neighbor information.
Related commands: ipv6 neighbor, reset ipv6 neighbors.
Examples
# Display all neighbor information.
<Sysname> display ipv6 neighbors all
Type: S-Static
IPv6 Address
FE80::200:5EFF:FE32:B800
Table 12-7 display ipv6 neighbors command output description
Field
IPv6 Address
Link-layer
VID
Interface
State
T
Age

display ipv6 neighbors count

Syntax
display ipv6 neighbors { { all | dynamic | static } [ slot slot-number ] | interface interface-type
interface-number | vlan vlan-id } count
View
Any view
Default Level
1: Monitor level
D-Dynamic
Link-layer VID Interface
0000-5e32-b800
IPv6 address of a neighbor
Link layer address (MAC address of a neighbor)
VLAN to which the interface connected with a neighbor belongs
Interface connected with a neighbor
State of a neighbor, including:
INCMP: The address is being resolved. The link layer address of the
neighbor is unknown.
REACH: The neighbor is reachable.
STALE: The reachability of the neighbor is unknown. The device will
not verify the reachability any longer unless data is sent to the
neighbor.
DELAY: The reachability of the neighbor is unknown. The device
sends an NS message after a delay.
PROBE: The reachability of the neighbor is unknown. The device
sends an NS message to verify the reachability of the neighbor.
Type of neighbor information, including static configuration and dynamic
acquisition.
For a static entry, a hyphen "-" is displayed. For a dynamic entry, the
reachable time (in seconds) elapsed is displayed, and if it is never
reachable, "#" is displayed (for a neighbor acquired dynamically).
12-10
State T
N/A GE1/0/1 REACH S
Description
Age
-