Arp Configuration Commands; Arp Check Enable; Arp Max-Learning-Num - HP E4510-48G Command Reference Manual

2

ARP Configuration Commands

ARP Configuration Commands

arp check enable

Syntax
arp check enable
undo arp check enable
View
System view
Default Level
2: System level
Parameters
None
Description
Use the arp check enable command to enable ARP entry check. With this function enabled, the
device cannot learn any ARP entry with a multicast MAC address. Configuring such a static ARP entry
is not allowed either; otherwise, the system displays error messages.
Use the undo arp check enable command to disable the function. After the ARP entry check is
disabled, the device can learn the ARP entry with a multicast MAC address, and you can also
configure such a static ARP entry on the device.
By default, ARP entry check is enabled.
Examples
# Enable ARP entry check.
<Sysname> system-view
[Sysname] arp check enable

arp max-learning-num

Syntax
arp max-learning-num number
undo arp max-learning-num
View
Ethernet interface view, VLAN interface view, Layer-2 aggregate interface view
2-1