Display Interface Vlan-Interface - HP E4510-48G Command Reference Manual

display interface vlan-interface

Syntax
display interface vlan-interface [ vlan-interface-id ]
View
Any view
Default Level
1: Monitor level
Parameters
vlan-interface-id: VLAN interface number, in the range of the numbers of existing VLANs on the device.
Description
Use the display interface vlan-interface command to display information about a specified or all
VLAN interfaces if no interface is specified.
Related commands: interface vlan-interface.
Examples
# Display the information of VLAN-interface 2.
<Sysname> display interface vlan-interface 2
Vlan-interface2 current state: DOWN
Line protocol current state: DOWN
Description: Vlan-interface2 Interface
The Maximum Transmit Unit is 1500
Internet protocol processing : disabled
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 001e-c16f-ae69
IPv6 Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 001e-c16f-ae69
Table 6-1 display interface vlan-interface command output description
Field
Vlan-interface2 current state
Line protocol current state
The physical state of the VLAN interface, which can be one of the
following:
Administratively DOWN: The administrative state of the VLAN
interface is down because it has been manually shut down
with the shutdown command.
DOWN: The administrative state of this VLAN interface is up,
but its physical state is down. It indicates that the VLAN
corresponding to this interface does not contain any port in the
UP state (possibly because the ports are not well connected
or the lines have failed).
UP: both the administrative state and the physical state of this
VLAN interface are up.
The link layer protocol state of a VLAN interface, which can be
one of the following:
DOWN: The protocol state of this VLAN interface is down,
usually because no IP address is configured.
UP: The protocol state of this VLAN interface is up.
6-2
Description