Dot1P-Priority (Igmp-Snooping View) - HP 6125G Command Reference Manual

With no parameters specified or with only vlan, count, or both of them specified, this command displays
all MAC address table entries, including static multicast MAC address entries and unicast MAC address
entries.
Related commands: mac-address multicast; display mac-address (Layer 2—LAN Switching Command
Reference).
Examples
# Display the static multicast MAC address entries for VLAN 2.
<Sysname> display mac-address multicast vlan 2
MAC ADDR
0100-0001-0001
--- 1 mac address(es) found
Table 4 Command output
Field
MAC ADDR
VLAN ID
STATE
PORT INDEX
AGING TIME(s)
1 mac address(es) found

dot1p-priority (IGMP-snooping view)

Syntax
dot1p-priority priority-number
undo dot1p-priority
View
IGMP-snooping view
Default level
2: System level
Parameters
priority-number: Specifies an 802.1p precedence for IGMP messages, in the range of 0 to 7. A higher
number indicates a higher precedence.
Description
Use dot1p-priority to set the 802.1p precedence for IGMP messages globally.
VLAN ID STATE
2 Multicast
---
Description
MAC address.
ID of the VLAN to which the network device identified by the MAC address
belongs.
Status of the MAC address; multicast indicates a static multicast MAC
address entry.
Outgoing ports of the multicast MAC address entry.
State of the aging timer. The aging timer for static multicast MAC addresses
has only one state NOAGED, which indicates that this entry never expires.
One static multicast MAC address entry is found.
PORT INDEX
GigabitEthernet1/0/1
GigabitEthernet1/0/2
GigabitEthernet1/0/3
GigabitEthernet1/0/4
6
AGING TIME(s)
NOAGED